Bicycle Engine Kit Wiring Tips Troubleshooting
bicycles reviews | bicycles videos | bicycles online
This video demonstrates wiring up the electrical side of your bicycle engine kit. After you have watched this video you simply can't go wrong, this is a step by step guide that will hopefully unbaffle the whole process for you.
Comments
-
Thanks buddy, that was very cleared and concise!
-
thank you very much for making this video I was having trouble getting a headache and once I saw your video I was very happy thank you very much
-
the killswitch is actually bad for the magneto .use the choke.
-
use it to charge your phone with whitewire
-
I disagree that you don't use the white wire, You should connect the white wire to the red wire on the kill switch and the black wire on the kill switch to an earth point on the engine (or frame if your engine is earthed to the frame).
-
TransformerCycles does a great job in help us to install a motor bike. They are helpful and useful .. recommend a must watch ... Thanks .. Tom
-
Thanks I found this very useful...
-
The Grubee SkyHawk kits come with all the proper connections so no need to cut or solder anything!
-
Cool vid, I can hear your Dog snoring behind you! lol :)
-
If you remake the video, remember that the Kill Switch makes a short circuit so the motor doesn't get a spark.
It takes all power from the Magneto and use's it up faster then the CDS that converts into high Voltage to make a spark.
My Motor on my bike did not fit and now i have it on and it fits.
Their is a bit of confusion with the wires as the book that's about 40 pages does not specify what to do with the 2nd wire of the kill switch.
Also the people who printed it did it in black and white with a crappy printer.
I found this video helpful at a certain degree.
7m 3sLenght
172Rating