Big Swingin' Cycles' Bionx Electric Bike Conversion Kits
bicycles reviews | bicycles videos | bicycles online
A quick primer on Bionx electric assist kits for bicycles. Covers the basics of the Bionx system - what it is, how it works, why it's the best system on the market, etc.
Comments
-
Brian, Nice video, very bad choice of bike to show the bionx system on. The installation at best is a 3.5 out of 10. You have snag hazards all over the bike.
1. On the down tube the cable is sticking out like it's pregnant. Use more sticking cable holders to keep in tight.
2. Cables leading to the motor, looks like the back of a double hump camel. again a snag hazard. Take the cable and wrap it around the frame a couple of times and make sure they are far enough down to use the wrap supplied to cover it. That will tighten both cables and make it look more streamlined.
3. Meter and Brake senor, the cables are all over the place. Use small tie wraps or S hooks to secure to brake cable and or shifting cables.
4. Please DON"T use wire cutters on tie warps. Go down to Lowe's go the electrical section and buy a couple of flush cutters. They are made to cut the tie wrap flush with the connector( no plastic knife blades to cut your customers). To date i have not seen one installer use flush cutter every video I have seen shows installers using wire cutters and leaving a nice little plastic edge to cut yourself on. -
Nice video. I taught at St Andrews College, Aurora back in 1981 for a short while. Brings back some nice memories.
-
try falco motors as well...
-
Bionx is in Aurora? That's two minutes from my house. I never knew that. I'm looking for a dealer everywhere.
-
Thank you for this video!
10m 2sLenght
20Rating